The reducing of heat gain through the outer walls of the buildings in summer will contribute in reducing the air conditioning costs. This is one of the best features of design requirements nowadays. To achieve this, the phase change materials (PCM) can be used as an embedded material in the walls to reduce heat transfer. The paraffin wax is one of the common materials used as a PCM in the building walls. The paraffin wax is used in this study with (20%) volume percentage in the external layer of the treated wall. In the present work, the treated wall (with embedded wax in the wall) and non-treated walls have been experimentally investigated. Two Iraqi wall models were employed to run the experiments, whereby these models were exposed to an external heat source using (1000 W) projector for each model. The temperatures were recorded at different locations in the walls during the charging and discharging periods. The results showed that the temperature of the internal surface for the treated wall was lower than that of the non-treated wall at the end of the discharging period (6 hr) where the temperature difference between the treated and non-treated walls was reached (1.6℃).
This paper describes a numerical method for calculating the temperature distribution and latent heat storage (LHS) in the treated wall (TW) and non-treated wall (NTW). The developed method was assumed that the outer cement layer (Iraqi wall) enveloping the external wall of building and houses are contains paraffin wax as a phase change material (PCM). (25%) is the volume percentage of paraffin wax is mixed with cement which forming a treated layer. A comparison results between the (TW) and (NTW) has been done. The paper presents a simple calculation of case study for air-conditioning in two walls type of residential building. The outer solar air temperatures as function of day time are considered for a hot day in summer (July) for Baghdad city. The aim of this paper was to obtain physical validation of the numerical results produced from using developed FORTRAN program. This validation was obtained through a comparison of numerical solution of two different wall compositions exposed to the same external and internal load conditions. The calculations on transient heat transmissions across different walls were conducted. It was found that when using the (TW) with (PCM) produces lower surface and heat flux towards the cooling space with respect to (NTW).
In this current experimental research, the amount of improvement in the thermal conductivity of HEC hybrid epoxy resins was studied by adding copper oxide nanoparticles CuONp and carbon nanotubes (CNTs) as hybrid additives in different proportions to select the sample with the highest thermal conductivity value to include it in the design of the Flat Plate Solar Collector FPSC as Thermal Interface Material TIM reduces thermal resistance between the absorber plate and the tube. Four groups of samples were prepared using a mass balance with a sensitivity of 0.01g and a magnetic mixing device, then poured into cubic plastic molds to take the shape of the sample. The first group consists of one sample of pure epoxy to calibrate the thermal properties testing device through it. The second group consists of five samples of epoxy loaded with CNTs by weight (1, 3, 5, 7.5, 10) %. The third group consists of five samples of epoxy loaded with CuONp with weight percentages of (1, 3, 5, 7.5, 10) %. The fourth group consists of five samples of epoxy loaded with CuONp and CNTs combined in weight percentages of (1, 3, 5, 7.5, 10) %. The thermal conductivity of the samples was measured experimentally using the hot disk analyzer technique to measure thermal specifications. After comparing the thermal conductivity values of the samples, the highest value was 1.57 W/mK for the HEC sample loaded with 10% CNTs, which represents 9.23 times higher than pure epoxy